Machine-data
| Stock no. | 1073-55744 |
| Category | Plate Bending Machine - 4 Rolls |
| Make | MG |
| Type | MH 2010 B |
| Year | 2003 |
| Control | NC |
| Storage location | 48683 Ahaus |
| Origin | Italy |
| Delivery time | immediately |
| Quotation | EXW- ex works (free on Truck) |
| Price | |
Technical details
| sheet width | 2050 mm |
| plate thickness | 10,00 mm ST |
| pre-bending | 8,00 mm ST |
| diameter of upper rolls | ~ 220 mm |
| side roll diameter | ~ 170 mm |
| diameter of lower rolls | ~ 190 mm |
| bending speed | ca. 2.0 + 5.0 m/min |
| Control | ELAP LYNX |
| oil volume | 80.0 Liter |
| voltage | 380 V |
| total power requirement | 5.5 kW |
| weight | 5000 kg |
| range L-W-H | 3500 x 1550 x 1400 mm |
** Current new price incl. accessories: approx. 90.000
** Special price on request
Equipment:
- Robust electro-hydraulic 4-roll plate bending machine
- 4-roll design offers a wide range of bending and rolling capabilities
- MG NC control unit "ELAP LYNX"
* Operation control of all rolls and machine axes
* Digital position display
* Manual operation via joysticks
* Movable control panel
- Two central rolls driven directly by hydraulic motors
- Conical rolling possible via roll tilting
- Side roll parallelism maintained via torsion shafts
- Pre-bending on both ends
- Diameters up to 1.1 times the top roll diameter are possible
- Forged and hardened rolls (hardness: 5355 HRC)
- Low-maintenance, robust machine design
- Permanent lubrication for all bearings
- Sturdy welded steel construction
- Selectable bending speeds (2 settings)
- Electro-hydraulic drop-end bearing for easy removal of rolled parts
- Pressure gauge/display for rolls
- Safety system (safety trip wire with switch unit)
- Operating manual (PDF)
Documents
no documents available
